All posts by toshiro

Connecting the AC IR Driver to the Ecobee 3

In the previous post we have created the IR Controller for the Samsung AC AR7000, so now it’s time to connect our Ecobee3 (modded for EU 220V Standard) to our Samsung AC.

Of course we need to add a new Relays to our electric panel and connect it to the Y1 pin in the ECOBEE plug panel.

Follow next schematic that is an improvement of first installation.
ecobee_ac

 

Connecting the Ecobee to the IR controller now is really simple!

Remove just the switch (keep the pull-down resistor) and connect instead the two pins AC_IR_DRIVER.

After that go to the Ecobee settings

Select Main Menu > Settings > Installation Settings > Equipment > Wiring

and configure manually to add Y1 and Y2 pin usage.

Test it by Main Menu > Settings > Installation Settings > Equipment > AC.

The thermostat will close the circuit every time he want to cool the apartment, closing the circuit is exactly like pushing the switch button on the IR Controller.

It will trigger a IR ON signal.

Once the thermostat want to stop, it will open the circuit (like releasing the button) and a IR OFF signal will be triggered.

(Of course you have to put your IR led in the AC direction or it will not work)

Let me know if it works also for you.

See you to the next post.

Arduino IR Samsung AR7000M A/C

I know… I’ve already one project to control my AC by my thermostat, but Samsung smart is not so open protocol and the work is going slowly but summer is already here!!!!

So I’ve already setup my thermostat to control my AC by IR, but let’s proceed by steps and create the hardware to communicate to turn on and off the AC.

BOM

First of all take:

Connect the IR led to the transistor to the Pin 3 of the Arduino following that scheme.

image

Here the 2N2222 PinOut:

image

Now connect the switch

image

The switch is temporary and will be substituted by the Ecobee contacts but for testing purposes is rather easy to implement and proof it’s working.

Code

Upload next code to make it working:

Test your new controller if drive correctly your AC.

Next step is to connect it to the Ecobee thermostat.
See you at next post.